Assembly - Greencut PRE100 Manual De Instrucciones

• Remove the product and accessories from the box carefully. Make sure all the items listed above are present.
• Inspect the product carefully to make sure it has not suffered any breakage or damage during transport.
• Do not discard the packaging material until you have thoroughly inspected the product and used it satisfactorily.
ATTENTION: If any part is missing or damaged, contact the Official Technical Service. Do not use
this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.

ASSEMBLY

1. Insert the frame bottom brace (B) into the bottom of the frame (A), then place each foot (C) on either side
so the attachment holes on the feet are aligned with the holes in the frame. Secure the parts using 4 M8x25
bolts (D) and M8 nuts (E). Tighten the fasteners securely using suitable spanners.
2. Attach a foot brace (F) to each foot and the frame. Ensure that the braces are diagonally opposite. Secure
the parts using 4 M8x20 bolts (G) and M8 nuts (E). Tighten the fasteners securely using suitable spanners.
3. Attach the hydraulic jack (H) to the jack plate (I) using 2 M8x20 cap screws (J) and spring washers (K). Ensure
that the jack is placed so that the handle is on he right-hand in relation to the arrow (AA) on the jack plate.
Tighten the fasteners securely using the supplied Allen key.
A
F
G
E
B
45
D
C
EN