Eschenbach makrolux Instrucciones De Uso página 9

Use
Place the brightfield magnifier [1] with the
even, flat side on the reading material so
that the product is slightly inclined towards
you.
Switch the lamp on by pressing the button
[2]. Pressing the button again will switch off
the lamp. The lamp will switch off automat-
ically after 30 minutes to conserve battery
power. If you still require the lamp, you can
simply switch it back on.
Now adjust the distance between eye and
reading material, until you see a sharp
image. Use the most comfortable distance
between your eye and bright field magnifier.
It is dependent on the reading glasses being
used and your eyes' adaptability.
Switch off the lamp when done.
Changing batteries
Switch off the lamp.
Open the battery case [3] by sliding it up
and taking it off the bright field magnifier.
Now remove the exhausted batteries and in-
sert new batteries as shown in the diagram.
•
You need 3 batteries, type Mignon (AA/
LR 6)/1.5 V. Always insert three new
batteries of the same type. Note the
position of the respective positive pole
(+)! The proper polarities are indicated in
the battery case.
Close the battery compartment by placing
it on the attachment plate [4] of the bright
field magnifier and pushing it downwards
until it clicks into place.
Note
If you normally wear glasses, you do not
need to take them off. The bright field mag-
nifier is designed to be used in conjunction
with your ordinary reading glasses.
- 9 -