Low Voltage Connections - Mvac M35 Manual De Instrucciones

Connect the low voltage wires to the low voltage
inlet on your unit. To do so, simply strip wires
over 1/2 cm (1/4"), remove the terminals from
the low voltage inlet on the unit, and proceed
according to the types of inlet and wire used.
Standard Low Voltage Inlet
All types of wire
Twist the stranded wire to tighten the loose
strands together before proceeding. Insert the
wire into the terminal (blue connector). Using
your wire strippers, tighten the terminal at
two places: at the front, to hold the wire in
place, and at the back, to tighten the insulator
around the wire (figure 3). If the insulator does
not completely cover the stripped wire, use
electrical tape to insulate the wire adequately,
and prevent all contact between the 2 wires.
Insert the terminal into the low voltage inlet
(figure 4).
To disconnect
Do not pull on wire. Simply remove the
terminal from the low voltage inlet.

LOW VOLTAGE CONNECTIONS

Installation
figure 3
figure 4
9