Unit Installation - Mvac M35 Manual De Instrucciones

UNIT INSTALLATION

Using the mounting plate provided
with your vacuum cleaner, secure the
unit to the wall (figure 1), at a height
allowing easy access for maintenance dirt
receptacle and/or bags.
figure 1
Since your unit has two air intakes,
simply choose one to connect your power
unit to the piping system according to its
location, the available space, etc. Make
sure the unused intake is properly sealed
with the provided cap.
If you want to use the other air intake,
first remove the bag adapter. To do so,
start by removing the clamp collar.
Then, grasp the adapter and the fitting,
and rotate the adapter so that its slot is
aligned with the small disc on the fitting;
then pull to remove the adaptor. Remove
the air intake fitting by pushing it from
the inside to the outside. Simply insert
it in the intake you want to use, and
reconnect the bag adapter. Don't forget
to seal the unused air intake with the
provided cap.
4
Installation