Adjus Ng Saddle Height - PIVOT cycles PIVOT SHUTTLE Team XTR Manual Del Usuario

Setting Compression Damping on the Fox 36 Fork
Only available on Team XTR Builds
To set compression, start from the open (or fastest) posi on by turning the black compression dial on the
top of the right fork leg counterclockwise un l it stops clicking.
Turn black dial clockwise in 2-8 clicks in (depending on rider weight). Most riders should feel comfortable
with 6 clicks in as a star ng point.
Lighter riders will generally prefer less compression damping (fewer clicks from open).
Setting Rebound Damping on the Fox 36 Fork
To set rebound, start from the open (or fastest) posi on by turning the red rebound dial on the bo om of
the right fork leg counterclockwise un l it stops clicking.
Turn red dial clockwise in 5-8 clicks in (depending on rider weight). Most riders should feel comfortable
with 8 clicks in as a star ng point.
Recommended Tire Pressure
Tire pressure is an important factor on having the bike ride properly. If the re pressure is too high, the re
will not conform to ground, reducing trac on. If the re pressure is too low, the re could pinch at.
It is important to have an accurate pressure gauge when se ng re pressure; preferably a digital gauge
with a 0.03 [bar] (0.5 [psi]) accuracy.
The recommended re pressure will vary slightly based on rider weight, riding style, and terrain.
Some riders may nd it helpful to start a ride at a slightly higher pressure than recommended and let out
a li le air throughout the course of the ride un l you nd your ideal riding re pressure.
Adjusting Saddle Height
The seat post collar on the Shu le can be loosened and ghtened with a 4mm hex wrench.
Before raising or lowering the seat height, using a 2mm hex wrench, loosen the head tube cable port
securing the dropper post housing.
The dropper post cable should be routed through the cable port on the driveside of the head tube. This
cable port cap is used to hold the dropper post cable and cycle computer wire in place.
Be sure to re- ghten the cable clamp on the head tube cable port a er adjus ng the saddle height. Make
sure not to pinch the cycle computer wire when ghtening the cable port.
4mm
Hex Wrench
www.pivotcycles.com
1.58 [bar] / 23 [psi] 1.93 [bar] / 28 [psi]
Hex Wrench
service-eu@pivotcycles.com
2mm
+49 711 4905 9800
BIKE SET-
5