CULUS Elica Guía De Instalación, Uso Y Mantenimiento página 23

determined as the control panel is equipped
with a LED light that changes colors as
follows, depending on the suction speed
(power):
Hood in stand-by: LED LIGHT SWITCHED
OFF
1 st suction speed (power) -GREEN LED
LIGHT
2 nd
suction speed (power) – ORANGE
LED LIGHT (amber)
3 rd
suction speed (power) - RED LED
LIGHT
4 th
suction speed (power) - RED LED
LIGHT (FLASHING)
Note: The 4 th suction speed (power) stays
on for 5 minutes, after which the suction
motor will position itself on the 2 nd speed.
If pressed again, the suction motor will switch
off (stand-by).
Grease filters need cleaning: FLASHING
GREEN LED light (read instructions found
under "Reset and configuration for filter
saturation signal")
Coal filters must be cleaned or replaced:
FLASHING ORANGE (amber) LED light
(read instructions found under "Reset and
configuration for filter saturation signal")
Note: The reset procedure may be activated
by both the control panel and the remote
control.
Center light check
The center light may be switched on and off
by pressing the T2 button on the control
panel.
Side light check (when scheduled)
The side lights may be switched on and off
by pressing AND HOLDING DOWN the T2
button on the control panel.
HOLDING DOWN
permitting to switch the hood on and off, it
also regulates the light intensity given from
the lights.
Note: The switching on and off functions
(and regulating function) alternate.
The regulation of the light intensity is not
the button, besides
available for hoods with neon lights.
Reset and
saturation signal
Switch on hood to any speed (see above
paragraph "Suction speed (power) selection")
Reset grease
(FLASHING GREEN LIGHT on control
panel)
First proceed with filter maintenance as
described in corresponding paragraph.
Press and hold down (for more than 3
seconds) the T1 button on the control panel,
the LED light will stop flashing indicating that
the signal reset has been carried out, the
hood will switch off.
Reset coal
(FLASHING ORANGE (amber) LED light)
First proceed with filter maintenance as
described in corresponding paragraph.
Press and hold down (for more than 3
seconds) the T1 button on the control panel,
the LED light will stop flashing indicating that
the signal reset has been carried out, the
hood will switch off.
Coal filter saturation signal disactivaction
(for particular applications)
Switch off hood (see above paragraph
"suction speed (power) selection").
Press and hold down (for more than 5
seconds) the T1 button on the control panel,
the LED light will start flashing GREEN
indicating that the coal filter saturation signal
has been disactivated.
In order to reactivate the coal filter saturation
signal, repeat operation, the LED light will
flash ORANGE (amber)
23
configuration for
filter saturation
filter saturation
filter
signal
signal