Unpacking/Assembly; Lifting/Handling; Place Of Installation - Corghi ICL IW Manual De Uso

WARNING
The unpacking, assembly, lifting and installation procedures which follow should be
performed according to instructions.
Failure to comply with these instructions could damage the machine and put the
operator at risk.
Remove the upper part of packing from the machine. Check the machine was not damaged
during shipping and identify pallet attachment points (Fig. 1).
At this point the machine is ready for installation.
N.B. If the machine is equipped with add-on sections, refer to the section on Installing
Additional Sections.
To remove the machine from the pallet, lift it as shown in Fig. 2.
The same lifting point must be used every time the site of machine installation is changed.
Remember to disconnect the machine from its pneumatic and electric power supply
before beginning such an operation.

PLACE OF INSTALLATION

WARNING
The place where the machine is to be installed must conform to applicable safety at
work regulations.
WARNING
The machine must not be installed in an open area.
Move the machine to the designated installation site, respecting the minimum distances
reported in Fig. 3.
- Relative humidity: 30% - 95% without condensation
- Temperature 0°C - +55°C
WARNING
The machine must not be operated in potentially explosive atmospheres.
26

UNPACKING/ASSEMBLY

LIFTING/HANDLING

Work environment conditions
ICL IW - ICL 8" IW operator's manual