Introduction; Supplied Accessories; Attaching The Stand; Symbols Used In This Manual - Sylvania LC427SSX Manual Del Usuario

Ocultar thumbs Ver también para LC427SSX:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

I
NTRODUCTION

Supplied Accessories

owner's manual
(1EMN24662)
If you need to replace these accessories, please refer to the part No. with the illustrations and call our toll free
customer support line found on the cover of this manual.

Attaching the Stand

You must attach the stand to the unit to have it as a table top unit. Be sure the front and rear of the stand match the proper
direction.
1
Spread a thick and soft cloth over a
table as shown below.
Place the main unit face down onto it.
Make sure not to damage the screen.
At least two people are required at
this step.
To remove the stand from this unit
Unscrew the Phillips pan screws indicated by above "
holes. After the screws are removed pull the stand up toward
the rear of the unit. Be careful not to drop the stand when you
remove it.
Note:
• When attaching the stand, ensure that all screws are tightly fastened. If the stand is not properly attached, it could cause the unit to fall,
resulting in injuries as well as damage to the unit.
• Make sure to use a table which can support the weight of this unit and is larger than this unit.
• Make sure the table is in a stable location.

Symbols Used in this Manual

The following is the description for the symbols used in this manual. Description refers to:
: Analog TV operation
TV
• If neither symbol appears under the function heading, operation is applicable to both.
4
EN
quick start guide
remote control
(1EMN24666)
(NF015UD)
2
Insert the neck under the bottom
of the main unit to the stand's hole
(shown by arrow
"screw
registration card
(1EMN24700)
batteries
cable
management tie
(AA x 2)
(1EM428657)
3
Drive Phillips pan screws in the 4
threaded holes at the bottom of the
).
stand until they are tight.
: Digital TV operation
DTV
Phillips pan screw for
attaching the stand x 4
(FPH34140)
AC power cord
(WAV0162LW001) or
(WAV0162LTE03)
screw holes
screw holes

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido