Cleaning And Maintenance; Technical Information - ECG VV 112 Manual De Instrucciones

OPERATING INSTRUCTIONS
The product is designed only for drying human hair. Do not use it to dry wigs or animals.
1. After cleaning wipe your hair with a towel and only after that use the hair dryer.
2. Insert the hair dryer into the power socket.
3. Select button position A and B, which is the correct temperature and air intensity.
4. While drying your hair model your hair style using a comb. Maintain a safe distance so that hair or the
scalp are not burned or that hair is not sucked into the infl ow grill of the product.
5. The air nozzle makes it possible to direct a narrow air current onto a comb or brush with which you are
doing your hair style.
6. After using the hair dryer, turn it off and disconnect it from the power supply.
7. The hanging loop can be used to hang the product.
Switch A Switch B
B3 –
A2 –
B2 –
A1 –
A0 – B1 –
A0 = product is turned off
A1 + B1 = 150 W, lower air fl ow intensity
A1 + B2 = 400 W, lower air fl ow intensity
A1 + B3 = 700 W, lower air fl ow intensity
A2 + B1 = 250 W, higher air fl ow intensity
A2 + B2 = 1100W, higher air fl ow intensity
A2 + B3 = 2200 W, higher air fl ow intensity
Note: For persons with decoloured, brittle, damaged or fine hair we recommend the use of the lower setting.
For persons with healthy, rough, strong, exotic and resistant hair we recommend, in order to save time
and eff ort to use the maximum amount of heat, which is created at the highest setting.

CLEANING AND MAINTENANCE

Before any maintenance disconnect the product from the electric grid! Clean the product always on a
product that has fully cooled down!
Never use the product in combination with a hair spray or other products in a spray. Sometimes using a small
brush remove dust and hair from the air inflow grill. Wipe the product with a damp (not wet) cloth and dry
with a soft dry cloth. Never clean the hair dryer under running water, do not rinse and do not submerge in
water!
Before putting the hair dryer away, always check that it has cooled down, it is clean an dry.

TECHNICAL INFORMATION

Noise level: 86 dB
Nominal voltage: 230 V ~ 50/60 Hz
Nominal input power: 2200 W
COOL button (cold air)
A1 + B + COOL = less cool air
A2 + B + COOL = cooler air
GB
19