You can set the speed of the high-performance motor to 12 levels
between a min and max by using the selector switch on the propul-
sion unit. To start, select the desired level. Then press the start button
and keep it pressed for approximately 3 seconds.
To switch off, either press the stop button
or turn the selector
switch back to
.
Attention: The mixer will only be switched on if the glass jug is
correctly fitted. A safety shutdown prevents operation without the jug.
ice crush
You can use the ice crush button to easily crush ice cubes. Fill in a
maximum of 8 ice cubes and close the glass jug with the lid
and cap. Place the selector switch on the program position. Now press
the ice crush button and the mixer will start an automatic programme
with different speeds and several pauses.
The programme automatically ends after about 30 seconds. You can
stop the programme at any time by pressing the stop button
.
smoothie
You can use the smoothie button to easily prepare smoothies. Place
the selector switch on the program position. Now press the smoothie
button and the mixer will start an automatic programme with diffe-
rent speeds.
The programme automatically ends after about 1 minute. You can stop
the programme at any time by pressing the stop button
.
interval
You can use the interval button, especially to easily clean the jar. Fill
the jug with a maximum of 1 litre of fresh water and add a few drops
of a washing-up liquid.
Place the selector switch on the program position. Now press the
interval button and the mixer will start an automatic programme with
different speeds and several pauses.
The programme automatically ends after about 45 seconds.
You can stop the programme at any time by pressing the stop button
.
Afterward, thoroughly rinse the entire jar with fresh water.
Glass Jar
The closing cap in the lid can be removed by rotating it in a clockwise
direction and can be used as a measuring cup (50 ml). The glass jar
can be dismantled, especially for cleaning. To do so, place the jar on
the table with the opening facing down. Rotate the screwed ring
counter-clockwise. You can now remove the blade assembly and the
sealing ring.
To assemble, the sealing ring is first attached to the blade assembly.
When doing so, make sure the sealing ring is properly seated on the
blade assembly.
Then place the blade assembly in the glass jar. Now place the screwed
ring on the glass jar and rotate in a clockwise direction until it is firmly
set.
11