DeWalt DWP352VS Serie Manual De Instrucciones página 31

unzip the rear of the bag, and shake out the dust. Every so often,
turn the bag inside out and brush the accumulated dust from the
inside.
OPERATION
WARNING: Always observe the safety instructions and applicable
regulations.
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
WARNING: To reduce the risk of serious personal injury, do not
use this tool in a stand that would invert it for use as a stationary belt
sander. This tool is not made for that application.
CAUTION: To reduce the risk of injury, secure the work and
maintain a firm grip on the sander. Friction between the sanding belt
and the work will tend to move the work backward and the sander
forward.
CAUTION: To reduce the risk of injury, always be sure the switch
is off before connecting the tool to power source.
1. Hold the sander off the work before starting the motor.
2. Lower the sander to the work, touching the rear part of the belt
first. Level the machine when moving it forward.
3. Guide the machine over the work in overlapping strokes. Allow
the sander to do the work.
4. Avoid applying excessive pressure. The weight of the machine
is usually sufficient for a fast smooth finish. A slight increase in
pressure may speed removal of material, but too much pressure
will slow the motor and decrease removal.
5. Work back and forth over a fairly wide area to obtain an even
surface.
6. Do not let the tool tilt. The edge of the belt can make deep cuts
into the surface.
7. Do not pause in any one spot during the sanding operation. The
belt will eat into the work and make the surface uneven.
8. Lift the tool from the work before turning the motor off.
9. Always be sure that the motor has completely stopped before
putting the tool down.
Proper Hand Position (Fig. 1)
WARNING: To reduce the risk of serious personal injury, ALWAYS
use proper hand position as shown.
WARNING: To reduce the risk of serious personal injury, ALWAYS
hold securely in anticipation of a sudden reaction.
Proper hand position requires one hand on the front handle (E), with
the other hand on the main handle (D).
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories. An accidental
start-up can cause injury.
Your D WALT power tool has been designed to operate over a
E
long period of time with a minimum of maintenance. Continuous
satisfactory operation depends upon proper tool care and regular
cleaning.
Lubrication
Your tool was properly lubricated before leaving the factory. In from
two to six months, depending upon use, take or send your tool to
an authorized service center for a complete cleaning, inspection
and lubrication. Tools used constantly on production jobs will need
relubrication more often. Also, tools "out of service" for long periods
should be relubricated before being put back to work.
29