Installing The Drill Into The Keyless Handle; Operation - Elite CID12 Manual De Usuario

WARNING
Keep in mind that this tool will always be in operation because it does not have to be plugged into an outlet.
Always put the switch in the off position and remove the battery pack before changing the bits.
INSTALLING THE DRILL IN THE KEYLESS HANDLE
WARNING
Before inserting a drill bit or other accessory, make sure the forward / reverse lever and trigger lock is in
the center off position to prevent accidental starts that may cause injury.
Do not attempt to tighten the bits (or any other accessory) by taking the sleeve from the front and turning
the tool on. This can cause personal injury or damage the sleeve.
When removing the drill bit from the tool, avoid that it touches your skin and wear suitable protective gloves
when taking the drill and accessories. The accessories may be hot after having been used for a long
period.
1. Hold the back end of the sleeve with one hand
and use the other to rotate the front end in direction
counterclockwise in order to open the sleeve jaws.
2. Fully insert the drill stem (or the
other accessory) in the keyless sleeve, with care for
keep the bit in the center of the grip jaws
3. Turn the front end of the sleeve clockwise
to hold the bit in its place.
4.Protect firmly by turning the front end of the
cuff clockwise while holding the end rear.
WIRELESS DRILL OPERATION
WARNING
Never put adhesive tape on the trigger switch to achieve continuous high-speed movement. In such condi-
tions the tool could fail, causing fires or personal injuries.
LOOSEN UP
TO TIGHT
HOLD
www.ELITETOOLS.co
Keep Working
9