Elite CID12 Manual De Usuario página 29

TORQUE ADJUSTMENTS
NOTE
To avoid damaging the tool or pushing the screws too far into the workpiece, release the trigger when you
feel the clutch slip.
CONTROL RING
THE CONTROL KNOB ADJUSTES THE TORQUE
LEVEL
• Use lower settings for light jobs.
• Use higher settings for heavy work.
CORRECT ADJUSTMENT FOR THE INSTALLATION OF SCREWS:
1. To begin, set the knob to the lowest setting.
2. Try the first tightening. If the drill works smoothly, proceed with the next screw.
3. If the drill clutch slides, increase the torque adjustment and continue until the tool turns the screw without
problems.
DRIVING THE SCREW
WHEN DRIVING THE FASTENERS
• Always start slowly and gradually increase the speed of the drill.
• Release the trigger when you feel the clutch slip.
• Always keep the screwdriver bit straight so as not to damage the screw.
11
www.ELITETOOLS.co
Keep Working