Technical Specifications - VelLight LEDS20RGB Manual Del Usuario

5. Battery
Refer to illustration D on page 2 of this manual.
 The remote control uses 1 battery type 3V lithium CR2025 battery
(included).
 To (re)place the battery, press on the side of the battery cover [D1]
and pull [D2] to slide it open.
 Insert the battery with the right polarity and close the battery
compartment by pushing it back into the housing of the remote control
until it snaps into place.
WARNING:
Do not puncture or throw batteries in fire. Dispose of
batteries in accordance with local regulations. Keep
batteries away from children.

6. Technical Specifications

IP rating
coating
colour
wavelength
light output
viewing angle
LED spacing
power supply
dimensions
Use this device with original accessories only. Velleman nv cannot
be held responsible in the event of damage or injury resulting from
(incorrect) use of this device. For more info concerning this product
and the latest version of this manual, please visit our website
www.velleman.eu. The information in this manual is subject to
change without prior notice.
© COPYRIGHT NOTICE
The copyright to this manual is owned by Velleman nv. All
worldwide rights reserved. No part of this manual may be copied,
reproduced, translated or reduced to any electronic medium or otherwise
without the prior written consent of the copyright holder.
V. 01 – 11/03/2015
LEDS20RGB
IP61
PU glue
red-green-blue
R=625 nm, G=525 nm, B=475 nm
± 300 lm/m
120°
33 mm
12 VDC/24 W (adapter included)
5 m x 10 mm
5 ©Velleman nv