Practical Applications - Hitachi CC 14SC Manual De Instrucciones

PRACTICAL APPLICATIONS

WARNING:
Never remove or install a workpiece while the cut-off wheel is rotating, to avoide personal
injury.
1. Procedure for fixing the cutting material (Fig. 5 and 6).
Quick Vise
Place the workpiece material between Vise (A) and Vise (B), raise the clutch and push the Screw Handle
to bring Vise (A) lightly into contact with the workpiece material, as shown in Fig. 5. Then, turn the clutch
down, and securely fix the workpiece material in position by turning the Screw Handle. When the cutting
job is completed, turn the Screw Handle 2 or 3 times to loosen the vise, and remove the workpiece
material, as shown in Fig. 6.
Vise (B)
Vise (A)
Clutch
2. Switch operation.
Lock-off Button
Handle
Fig. 7
Lock-off Button Trigger (Switch)
Fig. 8
Workpiece
material
Screw Handle
Fig. 5
To start and stop machine (Fig. 7 and 8).
The switch is switched on by manually pulling the trigger and cut off
by releasing the trigger to the original location.
The trigger switch lock-off button is designed to prevent inadvertent
operation of the power tool.
The trigger switch will not operate unless the lock-off button has
been pushed in.
When the trigger switch is released, the power goes off and the lock-
off button automatically returns to its original position, locking the
trigger switch.
Trigger (Switch)
Vise (B)
Vise (A)
Clutch
Screw Handle
Fig. 6
English
Workpiece
material
11