Echo DHC-200 Manual De Instrucciones página 18

Before you start
1. Battery
2. Battery charge status
button
Fitting and removing the battery
The hedge trimmer will operate when the battery is installed, the power indicator LED is lit, and the trigger switch, trigger
switch lockout, and interlock switch are engaged. Make sure the hedge trimmer is properly positioned to prevent loss of control
and possible serious injury. Keep movable parts of the hedge trimmer off the ground and away from objects that could become
entangled.
NOTE
The battery comes partially charged from the factory and needs to be fully charged before first use.
1. Battery
2. Ridge
1. Complete position
2. Uncomplete position
3. LED display
WARNING
3. Battery pack latch
3. Battery pack latch
4. Battery pack
4. When charging is complete, LED will remain GREEN.
∗ A fully discharged battery pack will charge in about 42 min-
utes. (LBP-560-100)
∗ A fully discharged battery pack will charge in about 88 min-
utes. (LBP-560-200)
∗ A fully discharged battery pack will charge in about 336
minutes. (LBP-560-900)
5. Verify battery is fully charged by removing battery from
charger, then pressing battery charge status button, and
checking LED display.
One green light indicates that the battery has 0-25%
charge.
Two green lights indicate that the battery has 25-50%
charge.
Three green lights indicate that the battery has 50-75%
charge.
Four green lights indicate that the battery has 75-100%
charge.
6. Disconnect battery charger from power supply.
Fitting the battery
1. Make sure power to unit is turned off.
2. Align ridges on battery with groove on hedge trimmer, and
insert battery until battery pack latch gets in the complete po-
sition.
IMPORTANT
Before using the hedge trimmer, make sure that battery is
set correctly with battery pack latch in the complete position.
NOTE
Battery pack latch is in the complete position when battery
pack latch is correctly engaged.
16