Starting Or Stopping The Tattooing Machine; Switching Back And Forth Between Two Tattooing Machines (Only Pu Ii) - Cheyenne POWER UNIT I Instrucciones De Uso

The preset piercing
110 pierces per second. The Power Unit
is automatically reset to this presetting
each time it is switched on.
 Adjust a suitable piercing frequency by
pressing the or arrow button.
The piercing frequency can be adjusted
in 10 increments from 60 to 160 pierces
per second.
6.3 Starting or stopping the tattooing
machine
CAUTION
Risk of injury when operating
the tattooing machine
If an unsecured tattooing machine is
started, uncontrolled movement can
occur due to vibrations, which can cause
the machine to fall or cause personal
injury.
 Hold the tattooing machine before you
start it or place it in a suitable holder.
To start the tattooing machine:
 Ensure that the voltage supply is
connected (see chapter 5.2 on page 23).
 Ensure that Power Unit is switched on
(see chapter 5.4 on page 23).
Cheyenne Power Unit I & Power Unit II
 Ensure that the tattooing machine is
frequency is
connected correctly (see chapter 5.5 on
page 24).
 Only PU II: Ensure that desired tattooing
machine is activated.
After switching on PU II, Tattooing
machine 1 is activated automatically.
To activate Tattooing machine 2, refer to
chapter 6.4 on page 25.
 Press the Start/Pause button
on the Power Unit to start the
tattooing machine.
The Operating LED illuminates.
If the connected tattooing machine does
not start:
 Observe chapter "10.1 Risk of injury
when lifting the tattooing machine" on
page 27.
To stop the tattooing machine:
 Press the Start/Pause button
again.
Alternatively, you can start and stop the
tattooing machine with the optional foot
switch:
 Step on the foot switch to start or stop
the tattooing machine.
The foot switch can also be used
in combination with
the Start/Pause button.
6.4 Switching back and forth between
two tattooing machines (only PU II).
CAUTION
Risk of injury when switching over
If an unsecured tattooing machine is
started, uncontrolled movement can
occur due to vibrations, which can cause
the machine to fall or cause personal
injury.
 Before switching over to the other
machine, switch off the tattooing
machine or stop it by pressing the
Start/Pause button.
 Hold the tattooing machine before you
start it or place it in a suitable holder.
It is only possible to use two tattooing
machines alternately on PU II.
 Stop the tattooing machine by
pressing the Start/Pause button.
 Press button 1 or 2 to activate the
respective tattooing machine.
 Firmly hold the tattooing machine
that you would like to start.
 Start the activated tattooing
machine by pressing
the Start/Pause button.
EN 25