Grundig TA 8680 Manual De Uso página 19

OPERATION ______________________________
Preparation
1
Remove all packaging and sticker materials
and dispose of them according to the applica-
ble local regulations.
2 Before using the appliance for the first time,
clean the appliance (See the "Cleaning and
care" section).
3 Make sure that the appliance is in an upright
position and on a stable, flat, clean, dry and
nonslip surface.
Note
When using the appliance for the first time,
7
smoke can develop due to production residues.
However, this does not mean that the appliance
is defective. The first time you switch it on use
the appliance as you normally would but with-
out bread. It is recommended to use the medium
setting of the +/- digital heat control
sufficient room ventilation.
Toasting
1
Insert the power plug into the wall socket.
2 Place bread slices into the bread slot
3
Use the+/- digital heat control
desired degree of browning between 1 and 7.
Notes
Sliding the +/- digital heat control
7
give the lightest degree of browning and slid-
ing it to 7 the darkest.
The browning degree can vary depending on
7
the type of bread.
When toasting several slices of bread consecu-
7
tively, the toaster will become hotter and thus the
bread will gradually become darker. Therefore
select an appropriate browning degree. Let the
toaster cool down after each toasting process
for a minimum of 30 seconds.
The degree of browning for a single slice will
7
be darker than for two slices, although the +/-
digital heat control
. Ensure
J
.
B
to select the
J
to 1 will
J
is set to the same level.
J
4 Press the start lever
snaps into place.
– The toasting process begins. The indicator
light of the stop button
the toasting process.
Notes
If the power plug is not connected into the wall
7
socket, the start lever
place.
The degree of browning can also be adjusted
7
during the toasting process with +/- digital heat
control .
J
5 The appliance automatically switches off as
soon as the set degree of browning has been
reached.
– The start lever
K
stop button light disappears. The toast
H
slices are pushed upwards and can be taken
out of the toaster.
Notes
To cancel the toasting process before it has fin-
7
ished, press the stop button
springs back up and the toast slices can be taken
out of the toaster.
After the start lever
7
use the high-lift function by pushing the start lever
upwards.
K
Caution
Be very careful when taking the toast slices out of
7
the toaster as the metal parts of the toaster and
also the bread can become very hot.
6
Disconnect the appliance from the wall socket.
Note
If toast slices get stuck in the toaster, switch the
7
toaster off immediately by pressing the stop but-
ton . Pull the power plug out of the wall socket.
H
Let the toaster cool down completely. Carefully
try to take the bread out of the toaster without
damaging the sensitive heating elements and
other parts. Do not use any electroconductive
objects to remove the bread from the toaster.
until it automatically
K
illuminates during
H
does not snap into
K
springs back up and the
H
. The start lever
springs back up, you can
K
ENGLISH
K
19