Connection With The Mains; Remote Control Operation; Cleaning And Maintenance; Replacing The Fuse - EuroLite BH-200 Manual Del Usuario

Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

Remote control operation

After connecting the device to the mains with the power-plug, switch on the left switch on the remote control.
The BH-200 starts running and the bubble emission starts via the left bubble wheel.
If you desire a greater bubble output, then additionally switch on the right switch on the remote control and
both bubble wheels run concurrently.
ATTENTION: The BH-200 can only operate when the left switch on the remote control has been
turned on.

CLEANING AND MAINTENANCE

We recommend a frequent cleaning of the device. Please use a soft lint-free and moistened cloth. Never use
alcohol or solvents!
There are no servicable parts inside the device except for the fuse. Maintenance and service operations are
only to be carried out by authorized dealers.

Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
DANGER TO LIFE!
International
L
N
DANGER TO LIFE!
Disconnect from mains before starting maintenance operation!
12/23 00026577.DOC, Version 1.1