Connection With The Mains; Operation - EuroLite Snow 6001 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Please note: for overhead rigging in public or industrial areas, a series of safety instructions have to be
followed that this manual can only give in part. The operator must therefore inform himself on the current
safety instructions and consider them.
The manufacturer cannot be made liable for damages caused by incorrect installations or insufficient safety
precautions!
Pull the safety bond through the attachment eyelet and over the trussing system or a safe fixation spot.
Insert the end in the quick link and tighten the safety screw.
The maximum drop distance must never exceed 20 cm.
A safety bond which already hold the strain of a crash or which is defective must not be used again.
Adjust the desired inclination-angle via the mounting-bracket and tighten the fixation screws.
Before taking into operation for the first time, the installation has to be approved by an expert!

Connection with the mains

Connect the device to the mains with the power-plug.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.

OPERATION

Switch the device on via the power switch. Connect the remote control with the Remote Control-socket.
DANGER TO LIFE!
International
L
N
By operating the snow switch on the remote
control the snow emission starts. It may
happen that the stand-by lamp turns off and
the snow emission stops. In this case the
device is heating up again and will be ready to
operate in approx. 1-2 min. This process
guarantees
temperature and the best snow emission
possible. The temperature is regulated by a
high quality thermostat.
The volume of snow produced is regulated via
the output knob.
CAUTION: The escape nozzle will heat up
during operation. Therefore do not touch
the nozzle until it has cooled down
completely.
14/27
an
appropriate
vaporization
00035972.DOC, Version 1.0

Publicidad

Tabla de contenido
loading

Tabla de contenido