Adjusting the awning
➤ Press and hold down the programming button (fig. 3 1, page 2) on the
back of the remote control.
✓ The awning briefly moves twice. After 6 seconds, the awning briefly
moves twice again.
If the awning does not briefly move twice and then after 6 seconds once
again as described, repeat step 3 from the beginning.
If the awning responds as described, release the programming button.
Continue with step 4 through 6.
I
NOTE
All prior controls (remote control, wind sensor, sun sensor, etc.)
will be cleared from motor memory at this point.
Step 4: Check the rotation direction of the motor
I
NOTE
Do not attempt to program other functions if the rotation direction
of the motor is not in order. Complete the procedure through
step 6, then begin with step 3 again.
➤ Press the
retracts and then extends again.
➤ Briefly press the
the rotation direction of the motor is correct and the awning moves in the
right direction.
➤ If the awning does not move in the right direction: Press the
for about 3 seconds.
✓ The awning briefly retracts and extends, indicating that the rotation direc-
tion of the motor has been changed.
➤ Briefly press the
that the rotation direction of the motor is correct and the awning moves in
the right direction.
46
and
buttons simultaneously until the awning briefly
(extend) or
(extend) or
(retract) button, to make sure that
(retract) button again, to make sure
PR4500
button
EN