Dometic PerfectRoof PR4500 Instrucciones De Uso página 52

Disposal
Problem
The motor is not
responding to the
remote control.
Awning moves in the
wrong direction after
pressing or
Awning does not fully
extend or extends too
far (fabric sags at
ends).
Awning does not fully
retract, or lead rail
moves out slightly after
awning retract.
52
Possible cause
The switch-on delay is
active.
If the awning has been
retracted automatically
by the wind sensor, it can
only be extended again
after 30 seconds.
The remote control bat-
tery is flat.
The remote control is not
properly set to the motor.
No power supply availa-
ble.
The motor is defective.
The remote control is not
properly set.
.
The outer limit is not
properly set.
The motor and remote
control are no longer syn-
chronised.
Suggested remedy
Wait for this time to elapse or switch the
power supply to the awning off and on
again to bypass the switch-on delay.
Only extend again, if the wind is not
present any more.
Briefly press the
the remote control LED does not light
up, the battery is flat.
Replace the battery (see chapter
"Changing the battery in the remote
control" on page 40).
Reset the motor and the remote control,
see chapter "Resetting the motor and
remote control" on page 45.
Check the electrical connections.
Retract the awning manually, see chap-
ter "Closing the awning manually in
emergencies" on page 41, and contact
the service partner in the respective
country.
Reset the motor and the remote control,
see chapter "Resetting the motor and
remote control" on page 45.
Reset the outer limit, see chapter
"Resetting the outer limit" on page 42.
Reset the motor and the remote control,
see chapter "Resetting the motor and
remote control" on page 45.
PR4500
or button. If
EN