AL-KO LSV 550/6 Manual De Instrucciones página 40

GB
NOTE For malfunctions that are not listed
in this table or that you cannot resolve yourself,
please contact our customer service.
Malfunction
Motor does not start.
Green ON button does not
latch when pressed in
Splitting wedge does not
move up/down, but motor is
running.
Splitting wedge has no force.
Unusual noises and vibra-
tions
Hydraulic pump whistles,
splitting wedge moves jerkily.
40
Cause
Motor protection switch has
tripped.
Mains plug or plug socket defec-
tive
Defective mains cable
Defective motor
No PE conductor or a phase not
connected.
Defective switch
Insufficient hydraulic oil
Defective hydraulic pump
Valve not open caused by loose
connection.
Operating lever or connecting
parts bent
For LSV 560/8: Wrong direction
of rotation of the motor caused
by incorrect phase connection of
the mains voltage
Insufficient hydraulic oil
Bent actuating lever
Insufficient hydraulic oil
Insufficient hydraulic oil
Air in hydraulic circuit
Help in case of malfunction
Remedy
Wait until the motor has cooled
down.
Have inspected and replaced, if
necessary, by a qualified electri-
cian.
Have inspected and replaced, if
necessary, by a qualified electri-
cian.
Have inspected and replaced, if
necessary, by a qualified electri-
cian.
Have inspected and replaced, if
necessary, by a qualified electri-
cian.
Top up hydraulic oil.
Have replaced by a specialist
company or AL-KO service cen-
tre.
Tighten loose parts.
Have bent parts repaired.
Reverse the phases of the
mains voltage at the plug socket
of the log splitter.
Have inspected and corrected, if
necessary, by a qualified electri-
cian.
Top up hydraulic oil.
Have replaced by a specialist
company or AL-KO service cen-
tre.
Top up hydraulic oil.
Top up hydraulic oil.
Loosen vent plug.
LSV 550/6 | LSV 560/8