Optional Accessories (Sold Separately); Battery Removal/Installation - Hitachi DS 14DV Instrucciones De Manejo

English

OPTIONAL ACCESSORIES (sold separately)

1. Battery (EB14S, EB14B, EB14H, EB1430H)
2. Plus driver bit
Bit No.
No. 1
No. 2
No. 3
Bit No.
3. Minus driver bit
a
0.8 mm
1 mm
a
4. Hexagon socket (for nuts and bolts)
Socket No.
7
8
Socket No.
Optional accessories are subject to change without
notice.
6
Screw size
2 – 2.5 mm
3 – 5 mm
6 – 8 mm
Screw size
4 mm
5 – 6 mm
Screw size
4 mm
5 mm
APPLICATIONS
Driving and removing of machine screws, wood
screws, tapping screws, etc.
Drilling of various metals.
Drilling of various woods.

BATTERY REMOVAL/INSTALLATION

1. Battery removal
Hold the handle tightly and push the battery latches
to remove the battery (see Figs. 1 and 2).
CAUTION
Never short-circuit the battery.
2. Battery installation
Insert the battery while observing its polarities (see
Fig. 2).
CHARGING
Before using the driver drill, charge the battery as
follows.
1. Connect the charger's power cord to a receptacle.
When the power cord is connected, the charger's
pilot lamp will blink in red. (At 1-second intervals).
2. Insert the battery into the charger.
Position the battery so that the nameplate faces
toward the caution plate of the charger and push
in the battery until it contacts the bottom plate. (See
Figs. 1 and 3.)
CAUTION
If the batteries are inserted in the reverse direction,
not only recharging will become impossible, but it
may also cause problems in the charger such as
a deformed recharging terminal.
3. Charging
When inserting a battery in the charger, charging
will commence and the pilot lamp will light
continuously in red.
When the battery becomes fully recharged, the pilot
lamp will blink in red. (At 1-second intervals.) (See
Table 1)
(1) Pilot lamp indication
The indications of the pilot lamp will be as shown
in Table 1, according to the condition of the charger
or the rechargeable battery.