Abus TVAC71200 Manual De Instrucciones página 16

Safety information
1. Power supply: 12 V DC
Only operate this device through a power source which supplies the mains power specified on the type
plate. If you are unsure of the installation location's power supply, contact your power supply company.
Disconnect the device from the power supply before carrying out maintenance or installation work.
2. Overloading
Avoid overloading electrical sockets, extension cables and adapters, as this can result in fire or electric
shock.
3. Cleaning
Only use a damp cloth to clean the device. Do not use corrosive cleaning materials.
Disconnect the device from the power supply before cleaning.
4. Accessories
Only connect devices that are expressly suitable for the intended purpose. Otherwise, hazardous situations
or damage to the device can occur.
5. Installation location
The illuminator is intended both for operation in protected outdoor areas and indoor areas. The product
may be damaged if it is dropped, even from a low height. Install the camera so that the image sensor is
not exposed to direct sunlight. Pay attention to the installation instructions in the corresponding section
of this user manual.
Never place the IR illuminator in close proximity to heaters, stoves, other sources of heat, or in direct
sunlight. Only operate the device in locations where temperatures stay within the permitted ambient
temperature range of -20°~50°C.
Warnings
Observe all safety and operating instructions before putting the device into operation for the first time.
1. Observe the following information to avoid damage to the power cable and plug:
•
Do not modify or manipulate the power cable or plug.
•
Do not pull the cable when disconnecting the device from the power – always take hold of the plug.
•
Ensure that the power cable is positioned as far away as possible from any heating equipment, as
this could otherwise melt the plastic coating.
2. Follow these instructions. Non-compliance with these instructions could lead to electric shock:
•
Never open the housing or power supply unit.
•
Do not insert any metallic or flammable objects into the device interior.
•
Use surge protection to prevent damage caused by overvoltages (e.g. in electrical storms).
3. Disconnect defective devices from the power immediately and contact your specialist dealer.
When installing the device in an existing video surveillance system, ensure that all devices have
been disconnected from the mains power circuit and low-voltage circuit.
If in doubt, have a specialist technician carry out assembly, installation and connection of the device.
Improper or unprofessional work on the power supply system or domestic installations puts both you
and others at risk.
Connect the installations so that the mains power circuit and low-voltage circuit always run
separately from each other. They should not be connected at any point or become connected as a
result of a malfunction.
16
English