Assembling The Work Light On The Tripod; Disassembling The Work Light; Operation; Using The Light - Powerfix Profi FCL-80115 Instrucciones De Montaje

Assembling the work light on
the tripod
Note: To assemble the work light on the tripod
you must firstly assemble the spotlights
handle piece on the mounting bracket
1
ceed as described in the chapter „Assembling the
spotlights and handle piece on the mounting
bracket".
Place the mounting bracket
and handle piece
The handle piece
1
direction of the retaining plates on the clamp
as otherwise, it cannot be fixed. Also ensure
that you place the holes on the underside of
the mounting bracket
clamp (see Fig. HI and HII).
8
Close the retaining plate of the clamp
(see Fig. HIII).
Flip the clip of the clamp upwards, so that it
catches in the retaining plate (see Fig. HIV).
Press the locking handle of the clamp
downwards to fix the mounting bracket
(see Fig. HV).

Disassembling the work light

DANGER OF ELECTRIC
SHOCK!
Remove the mains plug from the mains socket
before disassembly.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES!
Allow the light to cool down fully before disas-
sembling it.
To disassemble the individual elements, pro-
ceed in the reverse order as described in the
respective chapters.

Operation

Using the light (see Fig. I)
Completely unwrap the mains cable
Connect the mains plug to the mains socket.
and the
2
. Pro-
5
(with spotlights
5
) on the open clamp
1
must be orientated in the
on the pins of the
5
8
8
5
.
14
Switch the spotlight
ON / OFF switch
Switch the spotlight
ON / OFF switch
10
Loosen the wing bolt
into the desired position. Re-tighten the wing
bolt to fix the spotlight
3
position.

Maintenance and cleaning

2
.
8
, SHOCK!
8
Before cleaning the light, remove the mains
plug from the mains socket and wind the mains
cable on the cable winder
14
SHOCK!
To ensure electrical safety, never clean the light
with aggressive detergents or immerse it in wa-
ter.
CAUTION! RISK OF BURNS DUE TO
HOT SURFACES! Allow the spotlights
cool down completely.
Do not use solvents, petrol, etc. Otherwise the
light will be damaged.
Only clean with a dry, lint-free cloth.

Disposal

The packaging is made entirely of recyclable mate-
rials, which you may dispose of at local recycling
facilities.
Observe the marking of the packaging
materials for waste separation, which
b
a
are marked with abbreviations (a) and
numbers (b) with following meaning:
1–7: plastics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materials
are recyclable, dispose of it separately
for better waste treatment. The Triman
logo is valid in France only.
on by pressing the
2
into the „I" position.
15
off by pressing the
2
into the „0" position.
15
to tilt the spotlight
3
to the desired
2
DANGER OF ELECTRIC
.
12
DANGER OF ELECTRIC
GB/MT
2
to
2
23