Installation; Installing The Outside Station; Installing The Monitor; Wiring - Extel BORDY Instrucciones De Uso

6. Microphone
7. Camera direction adjustment holes
8. Terminal block to connect the wires

4. INsTAllATION

Note:
If you try the system before installing it, make sure the outside unit and monitor are not in the same room,
otherwise the videophone will emit piercing feedback noise (Larsen effect)
a. Installing the outside station (fig. 4)
1. Remove the screw under the outside station (1)
2. Tip the outside station forward (2)
3. The panel lens must be placed at a height of about 1.60 m.
4. Securely fix the rain shield using the screws (3) and install a silicone seal (4) between the shield and the wall to
avoid water from infiltrating. (Do not use acetic acid based silicone (vinegar smell)).
5. Connect the wires according to the wiring diagram (fig. 6)..
6. Engage the outside station (5) onto its rain shield (6) from the top.
7. Refit the fixing screw (7).
Important: Do not point the video camera directly at the sun or at reflecting surfaces.
Tip:
we recommend passing the cables through a protective sleeve to protect them from impacts and the weather.
b. Installing the monitor (fig. 5)
1. Fasten the wall mounting (2) so that the monitor screen is at a height of about 1.60m.
2. Connect the wires from the outside station (fig.6).
3. Connect the adapter plug (3) into the back of the monitor (without connecting it to the mains).
4. Position the monitor (1) and the wall mounting (2).
5. Connect the power supply block plug to a 230 V power outlet.
Note:
If the power supply cable has to be cut, ensure that polarity is respected (white bordered wire (+) (fig. 7)).

5. WIRING

To avoid disturbances and malfunction risks, do not pass the wire from the videophone through the same sheaths
as 230 V electric wires
Caution:
never double wires to increase their size.
a. Connecting the videophone (fig. 6)
Use the following wires:
1. Connect the wires following the wiring diagram (fig. 6).
2. Only 2 wires are needed to connect all the functions of the outside station: ring tone, video image,
intercom and opening controls (door opener and automation).
Respect the polarity between the screen and the outside station (no polarity to follow for the door opener con-
trol).
• Terminal "1" from the screen to terminal "1" on the station.
• Terminal "2" from the screen to terminal "2" on the station.
Important:
• For the wiring, please consult the label on the back of the outside station.
GB3
• 2 6 /10 th wires up to 25 m
• 2 1.5 mm 2 from 25 to 100 m
CFI EXTEL BORDY - 2015