Installation; Necessary Tools; Necessary Materials; Initial Conditions And Checks - Erreka MAGIC Manual Del Instalador

INSTALLATION

1

NECESSARY TOOLS

Set of screwdrivers
Fixed wrenches (13 mm and 17 mm)
Allen key (5mm)
Marker pencil
Level
2

NECESSARY MATERIALS

Screws for attachment to the base plate and the wall
angle
3

INITIAL CONDITIONS AND CHECKS

Initial conditions of the gate

Check that the size of the gate is within the
admissible range of the operator (see the
technical characteristics of the operator).

If the gate to be automated has a passage gate,
use a safety device to prevent the operator
from operating with the passage gate open.

The gate must have an in-ground central stop.

Environmental conditions


This device is not suitable for installation in
inflammable or explosive environments.
Electrical power supply installation

The electrical connections shall be made in line
with the instructions in the control panel
manual.
44
Installation manual
Tape measure
Electric drill and broaches

Use the electrical drill in line with the use
instructions.
Lubrication grease (graphite or lithium grease).

The gate must be easy to manipulate manually,
namely:
• This must be balanced, in order to ensure the effort
made by the motor is minimum.
• There should be no stiffness throughout its travel.

Do not install the operator in a gate which does
not work correctly in manual operation, as this
may lead to accidents. Repair the gate before
installing.

Check that the admissible environmental
temperature range for the operator is suitable
for the location.

The electrical cable section is indicated in:
Elements of the complete installation" on page 39.
"Fig. 1