Terminal Panel - NEC MultiSync LCD4010 Manual Del Usuario

Terminal Panel

1
AC IN connector
Connects with the supplied power cord.
2
RGB 1 IN (DVI-D)
To input digital RGB signals from a computer or HDTV
device having a digital RGB output.
* This connector does not support analog input.
3
RGB 2 IN (mini D-Sub 15 pin)
To input analog RGB signals from a personal computer or
other RGB equipment.
4
RGB 3 [R, G, B, H, V] (BNC)
IN connector: To input analog RGB signals or signals from
other RGB equipment.
This is also to connect equipment such as a DVD player and
HDTV laser disk player. A Sync-on-Green signal can be
connected to the G connector.
5
RGB OUT connector (BNC)
To output the signal from RGB 3.
6
DVD/HD connector (BNC)
Connecting equipment such as a DVD player, HDTV device,
or Laser disc player.
01_English 6
7
AUDIO IN 1, 2, 3
To input audio signal from external equipment such as a
computer, VCR or DVD player.
8
AUDIO OUT
To output the audio signal from the AUDIO IN 1, 2 and 3 jack.
9
VIDEO INPUT/OUTPUT CONNECTOR
VIDEO IN connector (BNC and RCA): To input a composite
video signal. BNC and RCA connectors are not available at
the same time. (Use only one input).
VIDEO OUT connector (BNC): To output the composite
video signal from the VIDEO IN connector.
S-VIDEO IN connector (DIN 4 pin): To input the S-video
(Y/C separate signal). See page 24, S-VIDEO MODE
SETTING.
10 EXTERNAL CONTROL (mini D-Sub 9 pin)
IN connector: Use when operating the LCD monitor from
the RGB equipment like a computer.
Out connector: To connect multiple MultiSync LCD4010 /
MultiSync LCD4610.
11 EXTERNAL SPEAKER TERMINAL
To output the audio signal from AUDIO 1, 2 or 3 jack.
English-6
08/09/2005, 16:26