HIKOKI SP 18SB Instrucciones De Manejo página 7

d) Use special care when working corners, sharp edges
etc. Avoid bouncing and snagging the accessory.
Corners, sharp edges or bouncing have a tendency
to snag the rotating accessory and cause loss of
control or kickback.
e) Do not attach a saw chain woodcarving blade or
toothed saw blade.
Such blades create frequent kickback and loss of
control.
SAFETY WARNINGS SPECIFIC FOR
POLISHING OPERATIONS
a) Do not allow any loose portion of the polishing
bonnet or its attachment strings to spin freely.
Tuck away or trim any loose attachment strings.
Loose and spinning attachment strings can entangle
your fingers or snag on the workpiece.
SPECIFICATIONS
Voltage (by areas)*
Power Input*
No-load speed
Weight (only main body)
*Be sure to check the nameplate on product as it is subject to change by areas.
STANDARD ACCESSORIES
(1) 180mm Wool Bonnet ................................................. 1
(2) Rubber Pad ................................................................. 1
(3) Wrench ........................................................................ 1
(4) Side handle ................................................................. 1
Standard accessories are subject to change without
notice.
APPLICATIONS
Polishing or shining painted metal surfaces, such
as those of automobiles, trains, elevators,
refrigerators, sewing machines, washing machines,
metal appliances, etc.
Polishing varnished surfaces of wooden furniture,
etc.
Shining synthetic resin or ebonite products.
PRIOR TO OPERATION
1. Power source
Ensure that the power source to be utilized conforms
to the power requirements specified on the product
nameplate.
2. Power switch
Ensure that the power switch is in the OFF position.
If the plug is connected to a receptacle while the
power switch is in the ON position, the power tool
will start operating immediately, which could cause
a serious accident.
PRECAUTIONS ON USING POLISHER
1. Do not leave the revolving polisher unattended
on the floor.
2. Always hold the body handle and side handle of
the polisher firmly.
Otherwise the counterforce produced may result
in inaccurate and even dangerous operation.
(110V, 115V, 120V, 127V, 220V, 230V, 240V)
2000 min
3. Extension cord
When the work area is removed from the power
source, use an extension cord of sufficient thickness
and rated capacity. The extension cord should be
kept as short as practicable.
CAUTION:
Damaged cord must be replaced or repaired.
4. Fixing the side handle
Screw the side handle into the housing.
5. Confirm the lock lever.
Confirm that the lock lever is disengaged by pushing
lock lever two or three times before switching the
power tool on (See Fig. 1).
6. Install the air cover on the air vent on the side where
the side handle is attached to divert the cooling air
flow of the motor during operation as much as
possible. Hook tab of the air cover to the air vent and
push in the tab when installing. Use a screwdriver
etc. to pull as shown in Fig. 3 when removing.
MOUNTING AND DISMOUNTING THE WOOL
BONNET (Fig. 1)
CAUTION: Be sure to switch OFF and disconnect the
attachment plug from the receptacle to avoid
a serious accident.
1. Mounting
(1) Attach the washer nut on the rubber pad.
(2) While pushing the lock lever with one hand, lock
the spindle by turning the rubber pad slowly with
the other hand.
Tighten the washer nut by using the supplied
wrench.
English
705 W
–1
2.1 kg
6