Working With The Palamat Elite; Pressure Pot - Heraeus PALA Palamat elite Instrucciones De Uso

7

Working with the Palamat elite

Attention!
Check the content of the shipping carton and compare with the scope of delivery described in the operating
instructions (see chapter 4 scope of delivery).
Attention!
Prior to operation it must be verified whether the information provided on the type plate correspond with the
local power supply data.
Attention!
The Palamat elite polymerization unit features a cold-appliance plug and a safety plug. Power cord and plug
must be checked for damage prior to the use. If any damage is found, the unit must not be connected to the
mains supply.
Attention!
The Palamat elite polymerization must be connected to the mains supply via properly installed sockets
with protective conductor connections (protection class I). The user must have easy access to the plug and
mains socket.
7.1

Pressure pot

To open the lid (1), locking lever must be in upright position. Turn the lid by 90°, tilt it and remove it from the pressure pot.
After completing the polymerization process, the handle must be in a perpendicular position to open the lid. The lid can only
be removed if it has been lowered into the pot after release of pressure. The lid is inserted and closed in reverse order. It must
ensured that the supporting strut of the lid fits into the grooves on the pressure pot rim.
Opening and closing the pressure pot
1
1 Place handle in perpendicular position and turn lid by 90°
2 Tilt lid slightly
3 Remove lid
The pot is closed in reverse order.
Polymerization unit for hot- and cold-curing resins
2
Operating Instructions
3
GB
- 7 -