Function Of The Unit; Changing The Battery; Emergency Stop Button; To Switch On & To Swicht Off - Virax Viper P25+ Manual De Instrucciones

3

Function of the Unit

3.1

Changing the battery

Insert battery until the catch clicks into place.
To remove press the catch and take out the battery.
If the battery voltage is lower than necessary, the LED lights (s. 3.5 LED chart). Charge
the battery in the charger!
3.2

EMERGENCY STOP Button

If there is any danger to personnel or the machine during the pressing process, press the
EMERGENCY STOP button immediately and release the trigger. The valve will open and the
piston will return to its initial position.
3.3 To switch on & to swicht off
To switch on, press the ON/OFF button.
To switch off, press the ON/OFF button.
3.4

To turn the press jaw

The press jaw can be turned through 360° depending on the application.
3.5

LED

LED caption:
LED lit=
Description
Tool switched on
Tool switched off
Battery level between 40% à 100%
Battery level between 0% à 40%
Battery level 0% / switch off after
Crimping cycle end
Crimping cycle interrupted
Battery plug in
Cycle number between 19500 and 19999
Cycle number equal to 20000
Automatic switch off / switch off after
3.6 To insert the press jaw
Remove battery!
 Open the bolt (1).
 Insert the appropriate press jaw for the job in hand (2).
 Lock the bolt (3).
LED flashing= LED off=
Battery
time
LED
1s
1s
all time
all time
10s
2s
2s
1 flash
all time
all time
1s
EN
Cycle/Service
LED
A
21