Kinderkraft TASTEE Manual De Usuario página 15

9. Mesh toy basket
B. Assembly of legs
Before assembling ends of the tubes, remove the plastic caps. Press the button (6) and unfold right and left
leg (3.1, 3.2). Place the left leg of the chair (3.1) in the side opening of the seat (1). Insert the leg until number
"1" appears in the side window. Repeat the procedure with the right leg (3.2). As a result, you should obtain
the structure shown in Fig. B2. Fix leg 2.1 at the rear, and leg 2.2 in the front of the chair (Fig. B3). WARNING:
The rear leg is equipped with wheels, preventing mistakes during the assembly process. The lower legs are
fitted correctly, when they are secured by spring-mounted pins
C. Attaching / removing the upholstery
Insert the top of the upholstery onto the back of the seat. Attach the sides of the pouch, wrapping it around
the arm support and securing hooks on each side of the seat (Fig. C).
In order to remove the shell, pull out all the belts (see section D) and unhook the hooks on each side of the
seat.
WARNING: Never use the product without upholstery.
D. Use of adjustable safety harness
WARNING: Use of safety harness is essential for the safety of your child. Using the tray does not ensure
proper child support. Always use safety harness.
Belts of safety harness can be adjusted and mounted in three positions depending on the height of the child.
Fastening belts of the safety harness to the product:
Put the plastic ring of the belts through the opening in the cover and in the seat (Fig. D2), without locking it
inside (Fig. D3). Repeat this procedure for all the belts. Connect shoulder, hip and crotch belt in the buckle.
Correct fastening of the belts of safety harness is shown in Fig. D1.
Disassembly of safety harness.
To completely remove the safety harness, proceed in the reverse order to the procedure described above.
To disconnect the belts of the safety harness, press the button in the middle of the buckle (Fig. D4).
E. Assembly and adjustment of the plastic tray
Attach the plastic tray to the chair by means of the clamping mechanism.
The tray can be set in one of three positions - marking is located on the armrest.
After inserting the tray, make sure that it is securely mounted.
In order to wash the tray, you can remove its top after releasing two catches (Fig. E2).
Completely dismantled tray may be attached to the leg, at the back of the chair.
F. Footrest adjustment
The footrest can be set in three different positions by pressing the two side buttons (Fig. F)
The YUMMY chair can be fitted with an additional footrest. To do this, insert the hook into one of the three
holes as shown in figure H1, H2.
WARNING! Do not stand on the footrest.
G. Adjusting the height of the chair and the backrest inclination
The chair can be set at 7 different heights.
To lift/lower the seat: simultaneously press the button to adjust the height of the seat on both sides and set
to the selected position (Fig. G1). WARNING: Do not do this when the baby is sitting in the chair.
The backrest of the chair can be set in three positions. To adjust the backrest, lift the lever located at back
(Fig. G2), tilt the backrest and place it in the desired position, then release the lever. The backrest is locked
automatically and you will hear a locking sound.
When selecting the lowest seat position, make sure that the indicator on the side indicates 7.
15