Prepare Burner Assemblies - Frigidaire FGDF4085TSA Instrucciones De Instalación

40" DUAL FUEL RANGE INSTALLATION INSTRUCTIONS
9

Prepare Burner Assemblies

9.1
Install Burner Caps
To prevent flare-ups use the cooktop with
all burner caps properly installed.
1. Place a burner cap on each burner head, matching
the cap size to the head size (see Figure 19). The
cap for each burner has an inner locating ring which
centers the cap correctly on the burner head.
Burner cap
Figure 19: Burner cap assembly
2. Make sure each burner cap is properly aligned and
level, as shown in Figure 20. Burners may not light or
burn evenly if the burner caps are not correctly place
on the head.
Correct cap placement
Figure 20: Burner cap placement
Burner cap
Locating ring
Burner head
Burner head
Incorrect cap placement
14
9.2
Check Ignition on Surface
Burners
Operation of electric igniters should be checked after
range and supply line connectors have been carefully
checked for leaks and range has been connected to
electric power. To check for proper lighting:
1. Push in and turn a surface burner knob to the
sparking position. All electronic surface ignitors will
spark at the same time. Only the burner you are
turning on will ignite.
2. The surface burner should light once the flow of gas
reached the surface burner. Each burner should light
within four seconds in normal operation after air has
been purged from supply lines. Visually check that
burner has lit.
3. Once the burner lights, the control knob should be
turned out of the LITE position.
Turn on each of the surface burners and check to see
that they light properly and that the flames are even.
Adjust settings if necessary.