Attaching The Antenna; Charging Skyhopper - WowWee FlyTech SKYHOPPER Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

A tta c h in g th e  ante n n a
When you first use the remote controller, you will
need to attach the antenna . To do so place the antenna
into the slot on the remote controller, and then turn it
counter-clockwise until it stops turning . Do not over-
tighten .
For optimal performance, extend the antenna before
flying Skyhopper .
NOTE: After you have finished flying Skyhopper, collapse the antenna on the remote
controller before storing it .
C ha rgi ng S ky hopp e r
Before flying Skyhopper for the first time (or if you have depleted the charge) you
will need to recharge it . This usually takes about 10 minutes, which provides up to 6
minutes of flying time .
You will know when the charge is almost depleted because the sound of the motor
will lower in tone . Skyhopper will also fly lower, and become less responsive to remote
controller commands .
NOTE: If the charge begins to exceed 15 minutes, you should replace all the batteries
in the remote controller .
To charge Skyhopper, do the following:
1 .
Pull out the charger cable located on the right
side of the remote controller .
Attachingtheantenna
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

450145024503

Tabla de contenido