Sleep Function; Crash Sensor; Replacing The Propellers - WowWee FlyTech SKYHOPPER Manual Del Usuario

Replacingthepropellers

Sleep function

Skyhopper is equipped with a sleep function . If it does not receive a command from
the remote controller for 1 minute, it will beep once . One minute after it beeps, (that
is 2 minutes in total), the LED power indicator in Skyhopper will turn off .
To wake Skyhopper from sleep, turn it off and then on again .

Crash sensor

Skyhopper is equipped with a crash sensor that allows it to detect impact and make
it stop flapping its wings . After impact, Skyhopper will ignore commands from the
remote controller for about 2 seconds . After that time, you can continue to send
commands to Skyhopper from the remote controller .
R e p l a cin g t h ep r opel lers
You can replace the propeller on your Skyhopper if the original one becomes damaged .
A spare propeller is included in the Skyhopper package . To replace the damaged
propeller, do the following:
1 . Make sure the remote controller and Skyhopper are turned OFF .
2 . Using a pair of pliers, carefully grasp the damaged propeller and pull it off the
axle as indicated .
3 . Carefully insert the new propeller into the axle, making sure it is secure .
Be careful not to damage the motor .
4 . Test the propeller by turning it manually to make sure it does not touch
the propeller guard .
12