Genesis GAG645 Manual Del Operario página 8

WArninG:
cutting tool may contact hidden wiring or its own cord. Contact with a "live" wire will also make exposed metal
parts of the tool "live" and shock the operator.
1. Always use proper guard with grinding wheel. A guard protects operator from broken wheel fragments.
2. Accessories must be rated for at least the speed recommended on the tool warning label. Wheels and other
accessories running over rated speed can flay apart and cause injury.
3. Hold the tool by insulated gripping surfaces when performing an operation where the cutting tool may contact
hidden wiring or its own cord. Contact with a "live" wire will make exposed metal parts of the tool "live" and shock
the operator.
4. Grinding wheel and guard must be securely attached as described in this manual before
connecting the grinder to a power source. Make sure that the guard is in good before operating the grinder.
5. Check the grinding wheel carefully visible defects before operation. Replace cracked, chipped, or warped wheel
immediately. Run the tool (with guard) at no load speed for about a minute, holding tool away from others. If wheel
is flawed, it will likely separate during this test.
6. Always use safety glasses or goggles. Ordinary eye or sun glasses are NOT safety glasses.
7. When using depressed center grinding wheels, be sure to use only fiberglass reinforced wheels.
8. use only flanges and clamp nut specified for this tool; do not over tighten the clamp nut on the grinding wheel.
excessive tightening can cause the wheel to crack during operation.
9. Be careful not to damage the spindle, the flange, or clamp nut (especially the installing surface) or the lock nut.
Damage to these parts could result in wheel breakage.
10.NeVeR use tool with wood cutting blades or other saw blades. Such blades when used on a grinder frequently
kick and cause loss of control leading personal injury.
11.Hold the tool firmly with both hands.
12.Keep hands away from rotating parts.
13.Make sure cord is clear of wheel. Do not wrap cord around your arm or wrist. If control of tool is lost, cord may
become wrapped around you and cause personal injury.
14.Make sure the wheel is not contacting the workpiece before the switch is turned on.
15.Before using the tool on an actual workpiece, let it run for a while. Watch for vibration or wobbling that could
indicate poor installation or a poorly balanced wheel.
16.use the specified surface of the wheel to perform the grinding. Never use the side or upper surfaces for cutting.
17.Watch out for flying sparks. Hold the tool so that sparks fly away from you and other persons or flammable
materials.
18.Do not leave the tool running. Operate the tool only when hand-held.
19.Do not touch the workpiece immediately after operation; it may be extremely hot and could burn your skin.
20.ALWAyS wear proper apparel including long sleeve shirts, leather gloves and shop aprons to protect skin from
contact with hot grindings.
21.use of this tool to grind or sand some products, paints and wood could expose user to containing hazardous
substances. use appropriate respiratory protection.
4-1/2" 6-Amp Angle Grinder
Operator's Manual
Hold tool by insulated gripping surfaces when performing an operation where the
GAG645