Troubleshooting; Spare Parts - Ribimex PAINTY W10 Manual De Instrucciones

Man. Istr. PaintyW10 nuovo
GB
DISMANTLING
Respect the local regulations in force when dismantling products that can no longer be used or repaired.
Separate AIR PAINT composite parts (plastic-cardboard-metal) by respecting differentiated waste
collection procedures.
TROUBLE - SHOOTING
PROBLEM
Paint drips on the surface
Paint excessively watery
or irregular
Inexistent paint coverage

SPARE PARTS

1) PAINTY W10 LT. BODY
2) PAINTY W10 RT. BODY
3) POWER SUPPLY CABLE + CABLE PASSAGE
BUSH + SWITCH + ANTI-DISTURBANCE CAPACITOR
4) ELECTRIC MOTOR U6620-230V
5) SCREWS 4x20
6) PLASTIC FILTER HOLDER
7) FILTER, DIAMETER 80 MM
8) PLASTIC FILTER COVER
9) RUBBER SUPPORT FEET
10) PLASTIC SPRAY GUN HOLDER
17-01-2008 9:47 Pagina 13
CAUSE
1) paint has been excessively diluted
2) too much paint delivered
3) work speed too slow
4) trigger pressed too often
5) airbrush too close to surface
being painted
1) paint excessively diluted
2) spray adjustment
3) increase work speed
4) airbrush clogged
5) spray gun distance
1) paint not diluted enough
2) airbrush jammed
3) airbrush/turbo compressor con-
nection hose damaged or clogged
4) air filter clogged
5) paint tank almost empty
6) container incorrectly closed
11) 2 M HOSE WITH CONNECTORS
12) SPRAY GUN
13) O-RING
14) SWITCH SLIDE
15) NYLON SHOULDER STRAP
16) INSTRUCTION MANUAL
17) VISCOSITY METER
18) INFLATION ACCESSORY
19) CABLE CLAMP
SOLUTION
1) add undiluted paint
2) decrease the quantity of
paint delivered by screwing
down the adjustment screw
(nr. 29 fig.4)
3) increase work speed
4) release the trigger when
inverting movement
5) increase distance of air-
brush from surface being
painted
1) add thickener
2) increase delivery of
paint by working on the
adjustment screw (nr.29
fig.4)
3) decrease work speed
4) clean airbrush (consult
respective paragraph)
5) decrease distance of
airbrush from surface
being painted
1) add thinner and check
product viscosity
2) clean airbrush (consult
respective paragraph)
3) replace hose
4) replace filter
5) fill tank
6) clean gasket and close
tank correctly