Rolling Code Synchronisation -
Programming
Your vehicle must be within operating range of
the gate or garage door opener. Make sure
you comply with the safety instructions even
when synchronising the rolling code.
1) Locate the training button (programming
button) on the gate or garage door opener
motor head unit. Exact location and colour
of the button may vary by gate or garage
door opener brand (refer to the operating
instructions of the gate or garage door
opener "Training additional remote
controls").
2) Press the training button (programming
button) on the gate or garage door opener
motor head unit (which will usually activate
a "training" light).
NOTE:
Following step 2, there are typically
30 seconds in which to initiate step 3.
3) Firmly press and release the programmed
HomeLink button. Press and release the
HomeLink button a second time to complete
the training process. (Some gate or garage
door openers may require you to do this
procedure a third time to complete the
training).
The gate or garage door opener should now
recognise the HomeLink signal and activate
when the HomeLink button is pressed.
EN
HomeLink
9