FX / RVE
General specifications and warning
- THESE SAFETY REGULATIONS INTEGRATE OR
COMPLEMENT THE LOCAL SAFETY REGULATIONS.
- DO NOT make hurried or inaccurate repairs that may
compromise the good running of the machine and the
safety of the operator.
- IN CASE OF DOUBT ALWAYS ASK FOR THE PRESENCE
OF SKILLED PERSONNEL.
- FOR ANY ELECTRIC/ELECTRONIC OR MECHANIC
TAMPERING OF THE MACHINE BY THE USER OR IN
CASE OF A NEGLIGENT USE OF THE MACHINE, THE
MANUFACTURER
RESPONSIBILITY AND THE USER WILL BE THE ONLY
ONE RESPONSIBLE AGAINST THE COMPETENT
AUTHORITIES FOR THE ACCIDENT PREVENTION.
1.2 - REFERENCE NORMATIVE
- The machine and its safety components have been
manufactured in compliance with the directives
indicated in the declaration of conformity.
1.3 - DESCRIPTION OF THE SYMBOLS
Many accidents are caused by a poor knowledge of
and by a non compliance with the safety regulations
to put into practice during the functioning and
maintenance works to be done on the machine.
In order to avoid any accidents, read understand
and follow all the warnings and cautions contained
in this booklet and those written on the plates located
on the machine.
To identify the safety messages included in this
booklet, following symbols have been used:
DANGER
This symbol is used in the safety messages
contained in the booklet in case of potential danger
situations or possibility to cause serious injuries or
dead.
IS
RELIEVED
FROM
ATTENTION
This symbol is used in the safety messages of the
booklet for any danger situation that, if disregarded,
may cause small or moderate injuries or damages.
The message can be used also in case of danger
situations that may cause damages to the machine.
ANY
IMPORTANT
This symbol is used in case of precautionary
measures to be taken in order to avoid any operation
that may reduce the life of the machine or for
important communication to the operator.
For clarity reasons, some illustrations of this booklet
show the machine without safety guards. DO NOT
USE THE MACHINE WITHOUT SAFETY GUARDS.
1.4 - COMPOSITION OF THE MACHINE
FX,RB,RVE kneading machines are the result of a
multiyear experience.
•
The machine consists of a bearing structure the motor
is housed in, of a head, which controls the kneading
spiral element, of a container to contain the dough
mix.
•
Depending on the concerned model, it is possible to
get a tip-up head or an extractable container.
DANGER
GB - 3