Lockout Menu - OHAUS CD-11 Manual De Instrucciones

CD-11 Indicator
2.6.6 Print Menu (Cont.)
STABLE
Press the G/N/T/ Menu button, Stb OFF is displayed.
When set to Stb ON, allows only stable weight values to be printed. When set
Stb OFF, prints immediate value with stability indication. In LFT, fixed to Stb ON.
Press the PRINT/ Units button for selections Stb ON or Stb OFF. Default setting is
OFF.
SAVE
Press the G/N/T/ Menu button to end this block, SAVE is displayed.
Press the G/N/T/ Menu button to save the Print menu settings. The next menu
LOCSW is displayed.
Press the PRINT/ Units button to go back to the rEAd menu without saving.
NOTE:If initial setup, go to the next paragraph. To exit from the SEtuP, press
the PRINT/ Units button to skip to LOCKSW, then Quit. Press the G/N/T/ Menu
button to go back to the weighing mode.

2.6.7 Lockout Menu

The Lockout menu (LOCSW) allows the user to lock and unlock the settings in the CAL, SEtuP, rEAd, and Print
menus to prevent tampering or accidental changes. When used in conjunction with the Lock Switch (jumper)
on the printed circuit board, the CAL, SEtuP, rEAd and Print menus can be read only and not changed.
Procedure
To select any of the items in the LOCSW menu, proceed as follows:
NOTE: If entering from the preceeding menu, disregard the first step.
With the Indicator ON, press and hold the G/N/T/ Menu button until MEnU is
displayed. When the G/N/T/ Menu button is released, CAL is displayed, then
press the PRINT/ Units button until LOCSW is displayed.
or
EN-19