Mode Menu; Units Menu - OHAUS Navigator NV Serie Manual De Instrucciones

Navigator
TM
4.2 Cal Sub-Menu
 Span [SpaN] (yes, no) - Initiates a span calibration procedure (zero and span). A span
calibration is important when initially setting up the balance.
 Lin [Lin] (yes, no) - Initiates a linearity calibration procedure (zero, mid-point and span).
4.3 Setup Sub-Menu
 Back Light [b.light] (on,off,Auto)-When Back light is set to "on" the balance will always "on".
When Back light is set to "Auto" the balance will turn on when a button is pressed or the display
weight changes.
 Auto Off [A-Off] (on, off) - When Auto Off is set to "on" the balance will turn off automatically
after 5 minutes of inactivity. Auto off is used to save battery power.
 IR Sensor [Ir.Func] (Off, Tare, Function, Print, Zero, Display) - These settings determine the
role of the IR Sensor. "Zero", "Print", "Function" or "Tare" allows the IR sensor to act the same
as the related button. "Display" activates the display if Display-Auto is set. "Off" disables the
sensor.*
 Filter [filter] (L1,L2,L3,L4 ) – set the amount of signal filtering
Stability
Stabilization time
 Auto Zero Tracking[AZt] (OFF,0.5d,1d,3d,5d,8d,10d) – Set the automatic zero tracking
functionality. The display will maintain zero until a change of "0.5d,1d,3d,5d,8d,10d" divisions
per second has been exceeded.
 Stable [Stab] (0.5d,1d,2d,5d) – Set the amount of the reading can vary while the stability
symbol remains on.
 Stable Compensation [Stab.C] (on, off) - Set the automatic stable tracking functionality. Set it
"off" for dosing or filling application.
Note: Bold always represents factory default Value
*
Availability of IR Sensor is dependent on model and region.

4.4 Mode Menu

This sub-menu activates modes so they will be available for use with the Mode button. Weigh mode is
always active.
 Parts Count [Count] (on, off) - Set on for the mode to be active.
 Percent [Percnt] (on, off) - Set on for the mode to be active.
 Check Weigh [CHECk] (on, off) - Set on for the mode to be active.

4.5 Units Menu

This sub-menu activates units so they will be accessible with the Units button. The units in the menu
must be turned "on" to be active.
Note: Available units and modes vary by model and local regulations.
L1———————————>L4
Less——————— > Greater
Faster——— >Slower
EN-7