HQ-Power VDPLOP1209RGB Manual Del Usuario página 4

•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks,
lamp explosion, crash, etc. Using the device in an unauthorised way will void the warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the
dealer will not accept responsibility for any ensuing defects or problems.
•
Mechanical wear and LEDs are not covered by warranty.
•
A qualified technician should install and service this device.
•
Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the
device against damage by leaving it switched off until it has reached room temperature.
•
This device is designed for professional use on stage, in discos, theatres, etc. The VDPLOP1209RGB should
only be used with an alternating current of 100 to 230 VAC – 50/60 Hz.
•
Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.
•
Use the original packaging if the device is to be transported.
•
Keep this manual for future reference.
4. Features
•
outdoor-rated, tri-colour LED wash light with a robust, extruded aluminium housing for all-weather
applications
•
innovative, touch-sensitive digital display eliminates rubberized control buttons
•
easy menu setting for stand-alone use
•
auto-programs available
•
DMX control via 3, 4, 5 or 9 channels
•
suitable for use on camera due to the flicker-free operation.
5. Overview
Refer to the illustrations on page 2 of this manual.
1 power out
2 touch display
6. Installation
Choose a suitable mounting spot. Mount the fixture in the desired angle using the included bracket. Connect the
power cord to the mains. Disconnect after use.
Mounting the Device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour without
deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a qualified
technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.
•
Overhead mounting requires extensive experience: calculating workload limits, determining the installation
material to be used... Have the material and the device itself checked regularly. Do not attempt to install
the device yourself if you lack these qualifications as improper installation may result in injuries.
•
For truss mounting, use an appropriate clamp (not incl.) and fit an M10 bolt through the centre of the
(folded) bracket.
•
Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
•
Make sure there is no flammable material within a 0.5 m radius of the device.
•
Have a qualified electrician carry out the electric connection.
•
Connect the device to the mains with the power plug. Do not connect it to a dimming pack.
•
The VDPLOP1209RGB has a power output [1] to supply power to another VDPLOP1209RGB. When
connecting several VDPLOP1209RGBs in a daisy chain via this output, make sure that the total current does
not exceed the power line's nominal current. Use power cables with an adequate section. If you do not use
the power linking feature, be sure to use the included screw-on cap to prevent any water from getting into
the power cords.
•
The installation has to be approved by an expert before the device is taken into service.
V. 04 – 08/01/2013
VDPLOP1209RGB
3 DMX output
4 bracket
4
5 DMX input
6 power input
©Velleman nv