Mount The Oven - GE CT9070SH3SS Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

8
BOTTOM TRIM INSTALLATION
• Slide oven out by 2" and attach the bottom trim through its mounting holes in front vertical brace
using two trim screws provided. Bottom trim lip must be placed under flange of bottom air duct.
SWO's installation
Exercise caution while sliding the unit back in after bottom trim installation. Installer needs to ensure
that the trim does not catch the edge of the cabinet and bend. Furthermore, the installer needs to
ensure that the cabinet itself is not damaged while the unit is slid back into position.
WARNING:
Do not slide oven out more than noted dimension, the unit can tip over and
fall causing serious injury & damage.
9

MOUNT THE OVEN

WARNING:
Mounting screws must be used. Failure to do so could result in the
oven falling out of the cabinet, causing serious injury.
NOTE: During oven mounting step, ensure that no damage is done to oven gasket which lines the
edge of oven cavity.
NOTE: Before drilling the pilot holes, make sure the oven is pushed as far back into the opening as it
will go and is centered.
NOTE: If the cabinet is particle board, you must use #8 x ¾" particle board screws. These may be
purchased at any hardware store.
A. Drill through the mounting holes (top and bottom) of the side trim for the #8 mounting screws
provided.
B. Secure the oven cabinet with the screws provided.
(hole locations
The Screws Must
Be a Minimum of
¼" (6 mm) From
the Front of the
Cutout.
Mounting
Hole
Locations
may vary)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ztsx1fpsn1ss

Tabla de contenido