Installing Or Removing Hedge Shear Blades; Installing The Hedge Shear Blades - Makita MU02 Manual De Instrucciones

► 1. Hedge shear blade 2. Hedge shear blade cover 3. Storage case
• Chip receiver for hedge trimming (for Hedge Trimmer)
NOTE:
• Some items in the list may be included in the tool package as standard accessories. They may differ from
country to country.
Installing or removing hedge shear
blades
CAUTION:
• Before installing or removing shear blades,
always be sure that the tool is switched off and
the battery cartridge is removed.
• When replacing the shear blades, always wear
gloves without removing blade cover so that
hands and face do not directly contact the blade.
Failure to do so may cause personal injury.
NOTE:
• Do not wipe off grease from the gear and crank.
Failure to do so may cause damage to the tool.
• For specific way of removing and installing
shear blades refer to the reverse of a package
for accessory shear blades.

Installing the hedge shear blades

1
2
► 1. Crank 2. Undercover 3. Shear blades
Prepare the crank, the undercover and new shear
blades.
1
3
2
1
► 1. Basic alignment line on the tool housing 2. Pins
Adjust the three pin position so that these three pins
are aligned with the basic alignment line on the tool
housing.
► 1. Recessed part of crank 2. Crank 3. Apply grease
4. Pins
Fit the crank with its recessed part facing downward
onto the pins. At this time, apply a small amount of
grease to the periphery of the crank using grease that
the shear blades as optional accessory are provided
with or that remains inside gear housing.
11 ENGLISH
3
2
1
2
3
4