Makita BO6040 Manual De Instrucciones página 7

Dust collection (optional accessory)
(Fig. 8 & 9)
If a Makita hose is used, you can connect the cuff to the
dust outlet directly. If other hose with an inner diameter of
24 mm, attach the joint between the dust outlet and the
cuff.
Sanding operation (Fig. 10)
CAUTION:
• Never switch on the tool when it is in contact with the
workpiece, it may cause an injury to operator.
• Never run the tool without the abrasive disc. You may
seriously damage the pad.
• Never force the tool. Excessive pressure may decrease
the sanding efficiency, damage the abrasive disc or
shorten tool life.
Turn the tool on and wait until it attains full speed. Then
gently place the tool on the workpiece surface. Keep the
pad flush with the workpiece and apply slight pressure on
the tool.
Polishing operation
CAUTION:
• Use only a Makita genuine sponge pad, felt pad or wool
pad (optional accessories).
• Always operate the tool at low speed to prevent work
surfaces from heating abnormally.
• Never force the tool. Excessive pressure may decrease
the polishing efficiency and cause motor overload,
resulting in tool malfunction.
1. Applying wax (Fig. 11)
Use an optional sponge pad. Apply wax to the
sponge pad or work surface. Run the tool to smooth
out the wax.
NOTE:
First, wax a less conspicuous portion of the work
surface to make sure that the tool will not scratch the
surface or result in uneven waxing.
2. Removing wax (Fig. 12)
Use an optional felt pad. Run the tool to remove
wax.
3. Polishing (Fig. 13)
Use an optional wool pad. Run the tool and apply
the wool pad gently to the work surface.
MAINTENANCE
CAUTION:
Always be sure that the tool is switched off and
unplugged before carrying out any work on the tool.
To maintain product safety and reliability, repairs, mainte-
nance or adjustment should be carried out by a Makita
Authorized Service Center.
7