Fuel Safety - Husqvarna 128LX Manual Del Usuario

4. Do a visual check of the spark arrester screen.
a) Replace the spark arrester screen if it is
damaged.
b) Clean the spark arrester screen if it is blocked.
CAUTION: If the spark arrester
screen is blocked the product
becomes too hot and this causes
damage to the cylinder and piston.
To install and remove the locknut
WARNING: Stop the engine, use protective
gloves and be careful around the sharp
edges of the cutting attachment.
A locknut is used to attach some types of cutting
attachments. The locknut has a left hand thread.
• To install the locknut, turn the locknut in the opposite
direction from the direction of rotation.
• To remove the locknut, remove the locknut in the
direction of rotation.
• To loosen or tighten the locknut, use a socket
wrench with a long shaft.
WARNING: When you loosen and
tighten the locknut there is a risk of injury
from the cutting attachment. Be careful
and do not touch the cutting attachment.
Note: Make sure that you can not turn the locknut by
hand. Replace the locknut after it has been put on
10
approximately 10 times. The locknut must be replaced
after it has been put on approximately 10 times.
Cutting attachment
WARNING: Read the warning instructions
that follow before you use the product.
• Do the regular maintenance. Let an approved
service center regularly examine the cutting
attachment to do adjustments or repairs.
• The performance of the cutting attachment
increases.
• The life of the cutting attachment increases.
• The risk of accidents decreases.
• Only use an approved cutting attachment guard.
Accessories on page 24 .
Refer to
• Do not use a damaged cutting attachment.
Grass trimmer head
• Make sure that you wind the grass trimmer line
tightly and equally around the drum to decrease the
vibration.
• Use only the approved grass trimmer heads and
grass trimmer lines. Refer to
page 16 .
• Use a correct length of the grass trimmer line. A long
grass trimmer line uses more engine power than a
short grass trimmer line.
• Make sure that the cutter on the cutting attachment
guard is not damaged.
• Soak the grass trimmer line in water for 2 days
before you attach the grass trimmer line to the
product. This increases the life of the grass trimmer
line.
• Refer to the instructions for the cutting attachment to
use the correct procedure to load the cord and the
correct cord diameter.
Grass blade
• Use correctly sharpened blades. An incorrectly
sharpened or damaged blade increases the risk of
injury. Refer to the instructions on the blade
packaging.
• Use correctly set blades. An incorrectly set blade
increases the risk of injury and damage.

Fuel safety

WARNING: Read the warning instructions
that follow before you use the product.
• Do not mix the fuel indoor or near a heat source.
• Do not start the product if there is fuel or engine oil
on the product. Remove the unwanted fuel/oil and let
the product dry. Remove unwanted fuel from the
product.
To trim the grass on
1570 - 001 - 14.10.2020