To Prepare For Grass Clearing; To Start A Cold Engine; To Start A Warm Engine; To Stop The Product - Husqvarna 128LX Manual Del Usuario

Note: To see where the fuel tank is on your product,
Introduction on page 2 .
refer to

To prepare for grass clearing

1. Apply support to the product with the harness during
grass clearing.
2. Make sure that the cutting equipment is parallel to
the ground.

To start a cold engine

1. Push the air purge bulb 10 times.
2. Move choke control to the full choke position.
3. Hold the body of the product on the ground with your
left hand. Do not step on the product. Pull the starter
rope handle slowly until you feel some resistance.
Note: Do not pull the throttle trigger while you start
the engine.
4. Pull the starter rope handle 3 times with force.
16
CAUTION: Do not pull the starter rope
until it stops. Do not let go of the starter
rope when it is fully extended. Release
the starter rope slowly. Failure to obey
these instructions can cause damage to
the engine.
5. Move the choke control to the half choke position.
6. Pull the starter rope handle until the engine starts.
7. Let the engine run for 10 seconds.
8. Move the choke control to the no choke position.

To start a warm engine

1. Slowly push the air purge bulb 10 times.
2. Move the choke lever to the HALF CHOKE position.
3. Pull the starter rope handle quickly until the engine
runs.
4. Move the choke lever to the NO CHOKE position.

To stop the product

• Push the stop switch to stop the engine.
Note: The stop switch automatically goes back to its
initial position.

Grass trimming with a trimmer head

To trim the grass
1. Hold the trimmer head immediately above the
ground at an angle. Do not push the trimmer line into
the grass.
2. Decrease the length of the trimmer line by 10-12
cm / 4-4.75 in.
3. Decrease the engine speed to decrease the risk of
damage to plants.
1570 - 001 - 14.10.2020