Battery Removal & Disposal
NOTE:
If uncertain as to how to remove your battery pack, we suggest you
take your sweeper to a reputable small appliance service technician to
have this service performed.
Follow these steps when battery removal is required.
This sweeper is equipped with Ni-Cd batteries and you need to dispose of them
properly. When the batteries are no longer good for use, they must be removed from
the sweeper for disposal. Do not remove the batteries for any reason other than
disposal of them. Call your nearest recycling center for information on the
recycling and disposal of Ni-Cd batteries.
WARNING: You must never use ordinary batteries for replacement
as these may leak and cause damage. Use only
battery pack X9725 provided for replacement.
Removal of Battery Pack
1.
Remove the extention handles and dust cup container.
2.
Turn unit over so that the base is facing upwards. Be careful not to turn the unit
ON. (Fig. 9)
3.
Push in locking tab and lift off battery compartment cover. (Fig. 10)
4.
Lift out battery pack and set aside.
5.
Insert the new battery pack into unit, ensuring that the Positive (+) terminal of
the battery pack corresponds with the positive (+) making inside the battery
compartment. Replace the battery compartment cover making certain that the
locking tab snaps in place.
IMPORTANT:
This appliance contains Ni-Cd batteries. The batteries must be
recycled or disposed of properly.
Locking
Tab
Fig. 9
Fig. 10
7
Modèle: V1725E
4,8 volts CC
1. Tête motorisée
2. Interrupteur marche/arrêt
3. Témoin de recharge
4. Coupelle à poussière
5. Brosse rotative
6. Couvercle de brosse transparent
Les illustrations peuvent différer du produit réel.
REMARQUE: Le balai motorisée sans cordon modèle V1725E
est expédiée avec des piles non chargées. Charger
les piles pendant 16 à 20 heures avant d'utiliser
l'appareil. N'utiliser que des piles de rechange
X9725
.
7.
Prise de recharge
8.
Poignée inférieure
9.
Poignées de rallonge en métal
10. Poignée supérieure
11. Adaptateur de recharge :
N'utilisez que
TechWorld AD-0720-
UL-8 7,5V-200 mA ou AD-0815-UL-8
7,5V-150mA
20