SOLAC VT8825 Instrucciones De Uso página 10

7. Motor shaft
8. Handle
9. Oscillation button
10. ON/OFF and speed selection switch
11. Turn-off timer
12. Telescopic tube
13. Base piece
14. Height adjustment ring
15. Fixing screw
16. Base trim
17. Feet
18. Motor shaft protector
19. Remote control
19. A. ON/OFF switch
19. B. Speed selection switch
19. C Turn-off timer
19. D. Mode switch
ASSEMBLY
Assembling the base
• Unscrew the 4 screws in the legs (17)
• Fit the 2 legs together (17), forming a cross and screw to the base piece (13)
using the 4 screws. 1. Cover the base using the trim (16), which must be
fitted with the height adjustment ring (14) removed.
• Extract the telescopic tube (12) to the desired height and adjust the height
of the fan using the height regulation ring (14).
• Fit the motor shaft (17) on the tube (12) and attach it by unscrewing the
fixing screw (15) slightly so that the telescopic tube (12) penetrates the body
of the fan (Fig.. 2), then tighten the fixing screw again and check that both
pieces are attached.
Assembling the grille and the blades
• Remove the motor shaft hood (2) and ring (4), and also remove the shaft
protector (18) in between them. Fit the rear grille (5) over the shaft (7) so
that the projections on the motor shaft coincide with the orifices on the
rear grille (5). Fig 3.
• Fix the grille to the shaft using the ring (4), tightening it in a clockwork
direction.
• Insert the blades (3) so that the slits on their upper parts meet the projec-
tions on the motor shaft. Fix the blades turning the hood (2) anticlockwise.
Check that they turn correctly. Fig. 4.
10